[torqueusers] Using TORQUE in a supercomputer with lots of CPU's - one node - gets job-exclusive

Silas Silva silasdb at gmail.com
Thu Feb 6 09:57:35 MST 2014


Yes.  This is SGI Altix.

I see, so I have to compile it with --enable-numa-suport?  TORQUE admin
guide is explanatory about that...

Thank you!

On Thu, Feb 06, 2014 at 09:38:45AM -0700, David Beer wrote:
> Silas,
> 
> Does this system use NUMA architecture?
> 
> 
> On Thu, Feb 6, 2014 at 7:34 AM, Silas Silva <silasdb at gmail.com> wrote:
> 
> > Hi there!
> >
> > I installed TORQUE and Maui successfully in a supercomputer, with 136
> > processors.  So, as you can see, this is not a beowulf cluster.  TORQUE
> > and Maui runs fine, but after the first job is running, the node (the
> > computer itself) state turns to be job-exclusive, so I can't run any
> > more job even though there are dozens of processors free.
> >
> > How to configure it (server_priv/nodes only?) to recognize other CPU's
> > as a different partition that jobs can be allocated to?
> >
> > Is multi-mom configuration the answer?
> >
> > Thank you!
> >
> > --
> > Silas Silva
> > _______________________________________________
> > torqueusers mailing list
> > torqueusers at supercluster.org
> > http://www.supercluster.org/mailman/listinfo/torqueusers
> >
> 
> 
> 
> -- 
> David Beer | Senior Software Engineer
> Adaptive Computing

> _______________________________________________
> torqueusers mailing list
> torqueusers at supercluster.org
> http://www.supercluster.org/mailman/listinfo/torqueusers


-- 
Silas Silva


More information about the torqueusers mailing list