[torqueusers] --enable-drmaa with 4.2.6

David Beer dbeer at adaptivecomputing.com
Wed Dec 4 14:31:21 MST 2013


On Wed, Dec 4, 2013 at 1:37 PM, Michael Jennings <mej at lbl.gov> wrote:

> On Wednesday, 04 December 2013, at 08:03:49 (-0500),
> Shouben Zhou wrote:
>
> > I do not use rpm, but use torque-4.2.6.tar. The following configure
> > command works for all old versions but not for 4.2.6:
> >
> > $ configure --enable-drmaa ...
>
> RPMs are built from the source tarball just the same.  The RPM part
> doesn't matter at all.
>
> I build such that --enable-drmaa is passed to configure, and it works
> fine.  As I said, you're likely missing a dependency.  Probably gperf.
>
>
For easier usage/error messaging TORQUE 4.2.7 and beyond will check for the
presence of gperf in order to pass configure if --enable-drmaa is passed to
the command line.

David


> Michael
>
> --
> Michael Jennings <mej at lbl.gov>
> Senior HPC Systems Engineer
> High-Performance Computing Services
> Lawrence Berkeley National Laboratory
> Bldg 50B-3209E        W: 510-495-2687
> MS 050B-3209          F: 510-486-8615
> _______________________________________________
> torqueusers mailing list
> torqueusers at supercluster.org
> http://www.supercluster.org/mailman/listinfo/torqueusers
>



-- 
David Beer | Senior Software Engineer
Adaptive Computing
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.supercluster.org/pipermail/torqueusers/attachments/20131204/023fbf21/attachment.html 


More information about the torqueusers mailing list