[torqueusers] installing torque-2.3.5 on mac snowleopard

[Yasaman Ghadarghadr]

Here is the gcc version.


gcc-v
Using built-in specs.
COLLECT_GCC=gcc
COLLECT_LTO_WRAPPER=/usr/local/libexec/gcc/x86_64-apple-darwin10/4.5.0/lto-wrapper
Target: x86_64-apple-darwin10
Configured with: ../gcc-4.5-20100107/configure --enable-languages=fortran --host=x86_64-apple-darwin10 --build=x86_64-apple-darwin10 : (reconfigured) ../gcc-4.5-20100107/configure --enable-languages=fortran,c++ --host=x86_64-apple-darwin10 --build=x86_64-apple-darwin10
Thread model: posix
gcc version 4.5.0 20100107 (experimental) (GCC) 


Thanks.!
Yasi 


On Jun 29, 2010, at 3:10 PM, Joshua Bernstein wrote:

> Interesting,
> 
> I'll have a look when I get on my Snow Leopard system and see if I can 
> track down the source of the problem for you.
> 
> What does gcc -version show for you?
> 
> -Josh
> 
> Yasaman Ghadarghadr wrote:
>> Thanks Josh - I tried removing "-pedantic" from the Makefile after running configure, but i got the same error. Your message did prompt me, however, to take a closer look at what the configure script was grabbing, and I notice that it is recognizing the wrong system architecture (I think). 
>> 
>> Configure returns:
>> 
>> checking build system type... i686-apple-darwin10.4.0
>> checking host system type... i686-apple-darwin10.4.0
>> 
>> while, my gcc that i am running is:
>> 
>> Target: x86_64-apple-darwin10
>> 
>> I do in fact want this to run as x86_64, so are there environmental variables i can set to get configure to recognize this correctly? I am pretty new to mac's, but it seems that this may be part of the problem.
>> 
>> Best;
>> Yasi
>> _______________________________________________
>> torqueusers mailing list
>> torqueusers at supercluster.org
>> http://www.supercluster.org/mailman/listinfo/torqueusers
> _______________________________________________
> torqueusers mailing list
> torqueusers at supercluster.org
> http://www.supercluster.org/mailman/listinfo/torqueusers