[torqueusers] mom log error "cannot connect to port 1023 in client_to_svr"

[Ken Nielson]

Steve Young wrote:
> Hi Ken,
>     Thanks for the insight. I check both hosts with netstat and see this:
>
> Proto Recv-Q Send-Q Local Address               Foreign 
> Address             State
> udp        0              0         *:1023                      *:*
>
> Which would also support when I saw in/out traffic on the interfaces 
> when I sniffed them with tcpdump.
>
> On my server I also see this in the logs:
>
> 02/23/2010 10:41:03;0004;PBS_Server;Svr;is_request;IS_STATUS received 
> from clienthost
>
> So some communication is going through. Any other idea's? Thanks,
>
> -Steve
>
>
>
>
> Also on a side note I just noticed a problem with the mom_priv/config 
> options. I'm using torque 2.4.3 and when I  tried to do the following 
> statements in the config file:
>
> $size[fs=/scratch]
> $arch ia64
> $opsys SUSE10
>
> Like the documentation on page ( 
> http://www.clusterresources.com/products/torque/docs/a.cmomconfig.shtml ) 
> suggests it complains with:
>
> 02/23/2010 09:40:05;0001;   
> pbs_mom;Svr;pbs_mom;LOG_ERROR::read_config, special command name size 
> not found (ignoring line)
> 02/23/2010 09:40:05;0001;   
> pbs_mom;Svr;pbs_mom;LOG_ERROR::read_config, special command name arch 
> not found (ignoring line)
> 02/23/2010 09:40:05;0001;   
> pbs_mom;Svr;pbs_mom;LOG_ERROR::read_config, special command name opsys 
> not found (ignoring line)
>
> After I remove the $ in front of them then it works fine. In config:
>
> size[fs=/scratch]
> arch ia64
> opsys SUSE10
>
> in logs:
>
> 02/23/2010 09:41:27;0080;   pbs_mom;n/a;add_static;config[4] add name 
> size value [fs=/scratch]
> 02/23/2010 09:41:27;0080;   pbs_mom;n/a;add_static;config[5] add name 
> arch value ia64
> 02/23/2010 09:41:27;0080;   pbs_mom;n/a;add_static;config[6] add name 
> opsys value SUSE10
>
>
We need to update the documentation for these. There are several options 
the code calls common_options that do not take a $ in the config file. 
Ironically, you may have noticed that for size there is a note expressly 
stating size does not take a $ but the documentation uses the $ in the 
example.

Ken