AW: Re: [torqueusers] stagein stageout when job killed.
dsternkopf at hpce.nec.com
Wed Jun 27 15:54:54 MDT 2007
Yes it will work. Sorry I only saw your batch script first.
----- Ursprüngliche Nachricht -----
Von: "Brock Palen" <brockp at umich.edu>
An: "Michael Gutteridge" <mgutteri at fhcrc.org>
Cc: "Danny Sternkopf" <dsternkopf at hpce.nec.com>; torqueusers at supercluster.org
Gesendet: 27.06.07 21:55
Betreff: Re: [torqueusers] stagein stageout when job killed.
Wonderful thank you,
yes the qsub manpage was not helpful in answering that, but I will
try it out. Thankyou.
Center for Advanced Computing
brockp at umich.edu
On Jun 27, 2007, at 3:47 PM, Michael Gutteridge wrote:
> I didn't see any explicit answer in the man page, though one could
> that from the "after job execution" statement. I do think that it's
> documented in the Torque admin manual.
> Though I digress. The answer is yes. "CopyFiles" runs after the
> job is
> killed, staging out the files listed in "-W stageout". At least at
> version 2.1.8.
> On Wed, 2007-06-27 at 21:31 +0200, Danny Sternkopf wrote:
>> look at '-W stageout=<file>' option in the manpage of qsub.
>> Best regards,
>> Brock Palen schrieb:
>>> When using stageout,
>>> If a users job is killed because of going over wall time, does
>>> out still run? if not is there a way to make that happen?
>>> Right now we have users put:
>>> cp /tmp/$PBS_JOBID/ouptput.dat ~/outputs/
>>> in there pbs file, but if the job is killed the cp is never ran,
>>> leaving the output files in /tmp/$PBS_JOBID
>>> Brock Palen
>>> Center for Advanced Computing
>>> brockp at umich.edu
>>> torqueusers mailing list
>>> torqueusers at supercluster.org
>> torqueusers mailing list
>> torqueusers at supercluster.org
More information about the torqueusers