[torqueusers] stagein stageout when job killed.

[Brock Palen]

Wonderful thank you,

yes the qsub manpage was not helpful in answering that, but I will  
try it out.  Thankyou.

Brock Palen
Center for Advanced Computing
brockp at umich.edu
(734)936-1985


On Jun 27, 2007, at 3:47 PM, Michael Gutteridge wrote:

>
> I didn't see any explicit answer in the man page, though one could  
> infer
> that from the "after job execution" statement. I do think that it's
> documented in the Torque admin manual.
>
> Though I digress.  The answer is yes.  "CopyFiles" runs after the  
> job is
> killed, staging out the files listed in "-W stageout".  At least at
> version 2.1.8.
>
> m
>
> On Wed, 2007-06-27 at 21:31 +0200, Danny Sternkopf wrote:
>> Hi,
>>
>> look at '-W stageout=<file>' option in the manpage of qsub.
>>
>> Best regards,
>>
>> Danny
>>
>> Brock Palen schrieb:
>>> When using stageout,
>>> If a users job is killed because of going over wall time,  does  
>>> stage
>>> out still run?   if not is there a way to make that happen?
>>>
>>> Right now we have users put:
>>>
>>> cp /tmp/$PBS_JOBID/ouptput.dat  ~/outputs/
>>>
>>> in there pbs file,  but if the job is killed the cp is never ran,
>>> leaving the output files in /tmp/$PBS_JOBID
>>>
>>> Brock Palen
>>> Center for Advanced Computing
>>> brockp at umich.edu
>>> (734)936-1985
>>>
>>>
>>> _______________________________________________
>>> torqueusers mailing list
>>> torqueusers at supercluster.org
>>> http://www.supercluster.org/mailman/listinfo/torqueusers
>>>
>>>
>>
>>
>> _______________________________________________
>> torqueusers mailing list
>> torqueusers at supercluster.org
>> http://www.supercluster.org/mailman/listinfo/torqueusers
>
>
>