[torqueusers] "Connection refused" immediately after installation

Jacques Foury Jacques.Foury at math.u-bordeaux1.fr
Fri Feb 9 06:23:16 MST 2007


Jeff Krimmel a écrit :
> Hi,
>
> I just went through the installation routine with the following commands:
>
> ========================
> ./configure --prefix=/opt/torque-2.1.6/ --exec-prefix=/opt/torque-2.1.6/
> make
> make install
> ========================
>
> I am using the torque-2.1.6.tar.gz tarball. I then try to initialize
> my Torque server, and I get the following:
>
> ========================
> [root at machinename torque-2.1.6]# pbs_server -t create
> [root at machinename torque-2.1.6]# qmgr
> Connection refused
> qmgr: cannot connect to server
> ========================
>
> Those are literally the five commands I issued. What could be refusing
> the connection this early in the process?
>

could you run a "ps aux|grep pbs" before running qmgr... and if there is 
a pbs_server process, use netstat to see if it is binded to its network 
port...

if not, check your server name parameter, and read the logs !

-- 

Jacques Foury
Ingénieur d'études
Institut de Mathématiques de Bordeaux
Université Bordeaux 1 / CNRS
Tel : 05 4000 69 56
Fax : 05 4000 21 23
http://www.math.u-bordeaux.fr/maths/cellule



More information about the torqueusers mailing list